Cummins/Onan 6CTA8.3 — Cleaning Batteries
Maintenance
For the Cummins/Onan 6CTA8.3, from the Cummins/Onan operator's manual.
Applies to: Cummins/Onan 6CTA8.3, Cummins/Onan DGBB, Cummins/Onan DGBC, Cummins/Onan DGCA, Cummins/Onan DGCB, Cummins/Onan DGCG, Cummins/Onan DGFA, Cummins/Onan DGFB, Cummins/Onan DGFC, Cummins/Onan DGFS, Cummins/Onan 4B3.9 engine, Cummins/Onan 4BA3.9 engine
Before you start
- Electrolyte is dilute sulfuric acid harmful to skin and eyes. Wear goggles and protective rubber gloves and apron.
- In case of contact, flush eyes with large amounts of water for minimum 15 minutes and call physician.
Procedure
- Keep batteries clean by wiping with a damp cloth when dirt appears excessive.
- If corrosion present, remove battery cables and wash terminals with baking soda solution.
- Be sure vent plugs are tight to prevent cleaning solution entering cells.
- After cleaning, flush outside of battery and surrounding areas with clean water.
- Coat terminals with light application of petroleum jelly or non-conductive grease.
Specs & values
- 1/4 pound baking soda added to 1 quart water
Full service-parts list: Cummins/Onan DGBB →, Cummins/Onan DGBC →, Cummins/Onan DGCA →, Cummins/Onan DGCB →, Cummins/Onan DGFA →, Cummins/Onan DGFB →, Cummins/Onan DGFC →
Source: Cummins/Onan operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.