Cummins/Onan — Stopping at the Control Panel (Manual Mode)
Operation
From a Cummins/Onan operator's manual — check it applies to your exact model before use.
Applies to: Cummins/Onan DGBB, Cummins/Onan DGBC, Cummins/Onan DGCA, Cummins/Onan DGCB, Cummins/Onan DGCG, Cummins/Onan DGFA, Cummins/Onan DGFB, Cummins/Onan DGFC, Cummins/Onan 4B3.9 engine, Cummins/Onan 6CTA8.3 engine, Cummins/Onan 6CTAA8.3 engine
Before you start
- Turning the O/Manual/Auto switch to O causes an immediate (hot) shutdown and bypasses Cool-down At Idle; avoid this if possible.
Procedure
- With the O/Manual/Auto switch in the Manual position, press the Manual Run/Stop button.
- The set completes its normal (Local Start) shutdown sequence.
- The set stops after the cool-down at idle timer (0 to 30 minutes) times out.
Full service-parts list: Cummins/Onan DGBB →, Cummins/Onan DGBC →, Cummins/Onan DGCA →, Cummins/Onan DGCB →, Cummins/Onan DGFA →, Cummins/Onan DGFB →, Cummins/Onan DGFC →
Source: Cummins/Onan operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.