Cummins/Onan — Configure System Using App (Getting Started)
Operation · EC-AGS+ Mobile Application
From a Cummins/Onan owner's manual covering: LP 2500, LP 3600, LP 5500, LP 6500, QD 10000, QD 12500, QD 5000, QD 5500, QD 6000, QD 8000, QG 2800, QG 4000…. Check it applies to your exact model before use.
Applies to: Cummins/Onan HDKA, Cummins/Onan HDKB, Cummins/Onan HDKC, Cummins/Onan HGJAA, Cummins/Onan HGJAB, Cummins/Onan HGJAD, Cummins/Onan HGJAE, Cummins/Onan HGJBB, Cummins/Onan HGLAA
Before you start
- For first time set up or after factory reset, the vehicle must be kept stationary for at least 30 seconds to allow the gateway accelerometer to be configured properly.
Procedure
- Download the EC-AGS+ app from the AppStore for iOS or Play Store for Android.
- Reconnect the generator set negative battery cable to power on the EC-AGS+ gateway.
- Verify that the EC-AGS+ gateway is powered by observing the LED blinking every 5 seconds.
- Turn on Bluetooth on the device containing the app.
- Select the EC-AGS+ App and select Start.
- Connect the gateway to the app via Discover EC-AGS+, Scan QR code, or gateway password.
- Read the End User License Agreement to the end and select Agree.
- Create a new password and select Assign Password.
- Select the generator set model and type; enter the Start Hours from the hour meter if available.
- Select Proceed to Dashboard.
Specs & values
- Operator range is approximately 30 feet from gateway and sensors.
- iOS 13.x and above or Android OS 8.x and above
- Bluetooth version 4.2 and above
Full service-parts list: Cummins/Onan HDKA →, Cummins/Onan HDKB →, Cummins/Onan HDKC →, Cummins/Onan HGJAA →, Cummins/Onan HGJAB →, Cummins/Onan HGJAD →, Cummins/Onan HGJBB →, Cummins/Onan HGLAA →
Source: Cummins/Onan owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.