The DSE4510 is a generator-set controller. It is used on generator sets from ATA and Winco, including the D1105-BG2, DE20I4, DE30I4 and DE45F4.
| Display | Icon based LCD display |
|---|---|
| Communications | USB Communications |
| Supply voltage | 8V continuous to 35V continuous (60V protection) |
| Operating temperature | -22ºF to +158ºF (-30ºC to +70ºC) for module, -40ºC to +70ºC with display heaters |
| Protections | Reverse Polarity Protection -35V continuous |
| Symptom | Remedy |
|---|---|
| WARNING ALARM ICONS | |
| ELECTRICAL TRIP ALARM ICONS | |
| SHUTDOWN ALARM ICONS | |
| Engine failure | The generator-set will automatically shut down and display the fault condition on the LCD. |
Fault codes and symptom→remedy steps extracted from this controller’s service/owner documentation; verify against the official manual before servicing. Extracted directly from this controller's manual.
Used across brands: ATA, Winco
| Symptom | Cause |
|---|---|
| Engine cranks but will not start | Improper fuel delivery to the unit |
| Engine starts, then stops and alarm light comes on | Engine oil pressure is low |
| Engine will not come up to speed after it starts | Insufficient fuel volume getting to the unit |
| Engine will not crank | Low/dead battery |
| No AC output from generator | Defective Diode |
Fault codes and symptom→remedy steps extracted from this controller’s service/owner documentation; verify against the official manual before servicing. Aggregated from the service documentation of generator sets built on this controller.