Service parts for the DE90F4
Grouped by system, with how many of each the parts manual calls for.
Air intake
1 requiredFuel system
1 requiredOil system
1 requiredBelts
1 requiredPrices captured from merchant listings; some links are affiliate links. Confirm against your serial number before ordering.
Specifications
| Fuel | Diesel |
|---|---|
| Frequency | 60.0 Hz |
| Standby kVA | 90000 |
| Emissions | Not specified |
| Controller | DSE4510 |
| Oil capacity | 13.5 L |
| Alternator | Stamford/AvK UC1274C |
| Voltage options | 120/240 V, 120/208 V, 277/480 V |
| Phase | Single |
| Rated current | 358 A |
| Power factor | 1.0 |
| Circuit breaker | 312 A |
| Battery group | Not specified |
| Battery voltage | 12 V |
| Battery quantity | 1 |
| Coolant capacity | 50 L |
| Max ambient | Not specified °C |
| Tank runtime | Not specified hr |
Engine
| Oil capacity | 13.5 L |
|---|---|
| Coolant capacity | 50.0 L |
| Aspiration | Turbocharged |
| Rated speed | 1800 rpm |
Maintenance & consumables
for the Iveco/FPT N45TM2| Item | Spec | Capacity | Part # | Interval | |
|---|---|---|---|---|---|
| Air filter | Air Filter Element | 8025818 | Amazon eBay | ||
| Fuel filter | Fuel Filter Elements | 2994048 | Amazon eBay | ||
| Oil filter | Oil Filter (2 req’d) | 2992544 | Amazon eBay FridayParts $55.99 | ||
| Belt | Alternator Belt | 500341810 | Amazon eBay |
Common questions
What engine does the Winco DE90F4 use?
The Winco DE90F4 is powered by the Iveco/FPT N45TM2 engine.
What fuel does the Winco DE90F4 use?
The Winco DE90F4 runs on Diesel.
What's the oil capacity on a Winco DE90F4?
The Iveco/FPT N45TM2 engine in the Winco DE90F4 has an oil capacity of 13.5 liters.
What is the cooling system capacity of the Winco DE90F4?
The Winco DE90F4 cooling system holds 50 liters (13.2 US gallons) for the radiator system including the engine, per the manufacturer specification sheet.
What voltages is the Winco DE90F4 available in?
The Winco DE90F4 is offered in 120/240 V, 120/208 V, 277/480 V, Single-phase.
How many cold cranking amps does the Winco DE90F4 require?
The Winco DE90F4 uses 1 battery, 12 V each, group Not specified, per the manufacturer specification sheet.
Which alternator is fitted to the Winco DE90F4?
The Winco DE90F4 uses a Stamford/AvK UC1274C alternator.
What oil filter does the Winco DE90F4 use?
The Winco DE90F4 uses oil filter part number 2992544.
Which fuel filter part number does the Winco DE90F4 take?
The Winco DE90F4 uses fuel filter part number 2994048.
What air filter fits the Winco DE90F4?
The Winco DE90F4 uses air filter part number 8025818.
Troubleshooting
5Symptoms & remedies
| Symptom | Cause |
|---|---|
| Engine will not crank | Low/dead battery |
| Engine cranks but will not start | Improper fuel delivery to the unit |
| Engine starts, then stops and alarm light comes on | Engine oil pressure is low |
| Engine will not come up to speed after it starts | Insufficient fuel volume getting to the unit |
| No AC output from generator | Defective Diode |
Fault codes and symptom→remedy steps extracted from this model’s service/owner documentation; verify against the official manual before servicing.
Fuel consumption
| Rating | Load | L/h | gal/h |
|---|---|---|---|
| Standby | 100% | 2.6 | 0.68 |
Available documents
This page was generated from the 1 manufacturer document above by automated extraction; every figure shown is copied from one of them. How the data is compiled.