Generac — Manual Transfer Switch Operation
Operation
From a Generac service manual covering: 10 KVA, 13 kVA, 8 kVA. Check it applies to your exact model before use.
Applies to: Generac EcoGen 6 kW, Generac GH-410 engine, Generac GH-426 engine, Generac GT-530 engine, Generac GT-530 engine, Generac GT-999 engine, Generac OHVI engine
Before you start
- Do not attempt manual transfer until all voltage is disconnected.
Procedure
- Set MLCB to Open.
- Set controller to OFF.
- Disconnect Utility.
- Locate manual transfer handle.
- Insert handle over operating lever.
- Actuate to UTILITY and STANDBY positions.
- Check for binding.
Tools required
- manual transfer handle Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Generac EcoGen 6 kW →
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.