Generac G0072100 — Remove From Service (storage longer than 90 days)
Maintenance · generator
For the Generac G0072100, from the Generac owner's manual.
Applies to: Generac G0072100, Generac G-Force 400 Series engine, Generac G-Force 800 Series engine, Generac G-Force 1000 Series engine
Before you start
- Explosion. Batteries emit explosive gases. Always disconnect negative battery cable first to avoid spark.
Procedure
- Start engine and allow it to warm up.
- Close fuel shutoff valve in fuel supply line and allow engine to stop.
- Set generator MLCB (generator disconnect) to OFF (OPEN) once engine has stopped.
- Disconnect battery charger AC input T1/Neutral cable (with white sleeve) at controller.
- Remove 7.5A fuse from generator control panel.
- Disconnect battery cables; remove negative battery cable first.
- Drain oil completely while engine is still warm, then fill crankcase with oil.
- Attach a tag to engine indicating viscosity and classification of the new oil.
- Remove spark plug(s) and spray a fogging agent into spark plug threaded openings; install and tighten spark plug(s).
- Remove battery and store in a cool, dry place. Clean and wipe down generator enclosure.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Generac G0072100 →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.