Cummins/Onan — Adjusting Values/Parameters (Adjust Menu)
Adjustments · PowerCommand 2100 Control
From a Cummins/Onan operator's manual — check it applies to your exact model before use.
Applies to: Cummins/Onan DGDA, Cummins/Onan DGDB, Cummins/Onan DGDK, Cummins/Onan 6BT5.9 engine, Cummins/Onan 6BTA5.9 engine
Before you start
- If the Home button or Previous Main Menu button is pressed before pressing the save symbol, the changes are not saved.
- Long periods of engine idling can eventually affect engine performance and may void engine warranty.
Procedure
- Press the button next to the symbol in the display until the + and − symbols are displayed.
- If necessary, press the button next to the or symbols to move to the numeric character you wish to change.
- Press the button next to the + symbol to increase the value; press the button next to the − symbol to decrease the value.
- After adjusting, press the symbol to save; make sure the cursor is on the last numeric character before pressing.
Specs & values
- Voltage Adjust: 5 percent of nominal
- Frequency Adjust: 5 percent of nominal
- Start Delay: 0 to 300 seconds (default = 0)
- Stop Delay: 0 to 600 seconds (default = 0)
- Rated To Idle delay: 0 to 10 seconds (default = 0)
- Idle Start: enable or disable (default = Disable)
Full service-parts list: Cummins/Onan DGDA →, Cummins/Onan DGDB →
Source: Cummins/Onan operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.