Cummins/Onan 2100 Series — Fuel Transfer Pump Motor Connections
Installation
For the Cummins/Onan 2100 Series, from the Cummins/Onan service manual.
Applies to: Cummins/Onan DFAB, Cummins/Onan DFAC, Cummins/Onan DFBF, Cummins/Onan DFCB, Cummins/Onan DFCC, Cummins/Onan DFCE, Cummins/Onan DFGB, Cummins/Onan DFGE, Cummins/Onan DFLB, Cummins/Onan DFLC, Cummins/Onan DFLE
Procedure
- Remove end bell cover for access to motor terminals.
- Disconnect brown lead from P103-3; connect to P103-6.
- Disconnect red lead from P103-2; connect to piggy-back terminal at P103-3.
- Cut white lead from ring connector at P103-4; strip 1/2 inch (12 mm).
- Splice white lead to harness lead P103-WHITE.
- Connect each lead of five-lead harness to marked motor terminal.
- Connect red motor lead to piggy-back terminal at P103-3.
- Secure end bell cover.
Specs & values
- Strip 1/2 inch (12 mm) of insulation
Full service-parts list: Cummins/Onan DFBF →, Cummins/Onan DFCC →, Cummins/Onan DFCE →, Cummins/Onan DFGB →, Cummins/Onan DFGE →, Cummins/Onan DFLB →, Cummins/Onan DFLC →, Cummins/Onan DFLE →
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.