Generac — Stator Removal

Repair & overhaul

From a Generac service manual covering: QUIETPACT 55, QuietPact 65, QuietPact 75. Check it applies to your exact model before use.

Applies to: Generac QUIETPACT 55, Generac QuietPact 65, Generac QuietPact 75, Generac GTV-760 engine

Procedure

1. Perform enclosure/panel removal steps 1-12.
2. Remove six air in duct base panel bolts and remove air in duct base.
3. Remove four standoff bolts from top of stator.
4. Disconnect Wire 4 and Wire 0 from brush holder assembly.
5. Remove two brush holder screws and remove brush holder assembly.
6. Remove Wire 11 and Wire 33 from circuit breaker.
7. Remove Wire 66 and Wire 77 from Battery Charge Rectifier.
8. Remove Wire 55 from R1 resistor.
9. Remove Wire 11, Wire 22 and Wire 6 from Voltage Regulator.
10. Remove Wire 2 from DPE circuit breaker.
11. Remove Wire 22 and Wire 44 from ground lug.
12. Remove upper bearing carrier.
13. Remove stator.

Full service-parts list: Generac QUIETPACT 55 →, Generac QuietPact 65 →, Generac QuietPact 75 →

Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →