Generac — Starting the Generator
Operation · Generator control panel
From a Generac owner's manual covering: 9592, GN-570, Q-55G, Q-70G. Check it applies to your exact model before use.
Applies to: Generac 9592, Generac Q-55G, Generac GN-480 engine, Generac GN-570 engine
Before you start
- Holding the start/stop switch longer than 15 seconds can damage the starter motor.
Procedure
- Turn off electrical loads using the vehicle main breaker or transfer switch.
- If not started in more than two weeks, press Fuel Pump Primer for about 30 seconds.
- Skip the primer step if the engine is warm.
- Hold start/stop switch at START; release when engine starts.
- Do not crank longer than 15 seconds; try again if needed.
- Let engine run at no-load a few minutes to stabilize and warm up.
- Turn on electrical loads using the main breaker or transfer switch.
Specs & values
- Panel has a 15 amp fuse and line breakers
Full service-parts list: Generac 9592 →, Generac Q-55G →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.