Generac — Rotor Removal

Repair & overhaul

From a Generac service manual covering: QUIETPACT 55, QuietPact 65, QuietPact 75. Check it applies to your exact model before use.

Applies to: Generac QUIETPACT 55, Generac QuietPact 65, Generac QuietPact 75, Generac GTV-760 engine

Procedure

1. Perform stator removal procedure steps 1-13.
2. Remove carburetor air tube and fuel line.
3. Remove two lower control panel nuts and unplug choke solenoid connector.
4. Disconnect bullet connectors and switches and remove control panel.
5. Remove four vibration mount nuts and two safety nuts.
6. Lift generator out of bottom tray.
7. Remove blower housing screws and blower housing.
8. Remove side belt tensioner bolts and remove belt.
9. Remove rotor pulley bolt and use steering wheel puller to remove pulley.
10. Lift rotor and bottom bearing carrier out; press rotor/bearing from carrier.

Full service-parts list: Generac QUIETPACT 55 →, Generac QuietPact 65 →, Generac QuietPact 75 →

Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →