Generac GT-530 — Setting The Exercise Timer (8 kW)
Operation · Control panel
For the Generac GT-530, from the Generac service manual.
Applies to: Generac GH-410 engine, Generac GT-530 engine, Generac GT-990 engine, Generac GT-999 engine
Before you start
- The exerciser will only work in the AUTO mode.
Procedure
- Verify that the AUTO-OFF-MANUAL switch is set to AUTO.
- Press and hold the Set Exercise switch for several seconds.
- All red LEDs stop flashing immediately and the generator starts.
- Generator runs for approximately 12 minutes and then shuts down.
- Exerciser is now set to run at this time of day each week.
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.