Generac G9.0L G26 — Modify a Page Setting
Operation · PZ410 Controller
For the Generac G9.0L G26, from the Generac service manual.
Applies to: Generac 130 kW PME, Generac 150 kW PME, Generac 9.0L Gaseous Engine (G26) engine
Procedure
- Verify the desired setting is highlighted on the page and press ENTER.
- Press ENTER again to highlight the value if needed.
- Use the navigation arrows to change the value.
- Press ENTER to confirm, or ESCAPE to cancel.
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.