Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Servicing the Air Cleaner

Generac G-Force 400 Series / RTG16EZA3 — Servicing the Air Cleaner

Maintenance

For the Generac G-Force 400 Series / RTG16EZA3, from the Generac owner's manual.

Applies to: Generac G-Force 400 Series engine, Generac G-Force 800 Series engine, Generac G-Force 1000 Series engine

Before you start

  • Never operate engine without the air cleaner installed.
  • Never clean air filter element with gasoline or low flash-point detergents.

Procedure

  1. Lift lid and press OFF to stop generator.
  2. Remove front panel.
  3. Remove cover clips and air cleaner cover.
  4. Remove old air filter element and discard.
  5. Clean air cleaner enclosure of dust and debris.
  6. Install a new air filter element.
  7. Install air cleaner cover and fasten cover clips.
  8. On 14–24 kW, verify air inlet duct is connected to cover.

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →