Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Preparing for Maintenance

Generac G-Force 1000 Series — Preparing for Maintenance

Maintenance · Generator

For the Generac G-Force 1000 Series, from the Generac owner's manual.

Applies to: Generac G-Force 400 Series engine, Generac G-Force 800 Series engine, Generac G-Force 1000 Series engine

Before you start

  • Automatic start-up. Disconnect utility power and render unit inoperable before working on unit.

Procedure

  1. Set main utility disconnect to OFF (OPEN).
  2. Lift lid and set MLCB (generator disconnect) to OFF (OPEN).
  3. If running during a utility outage, allow generator to run and cool down one minute with no load.
  4. Press OFF button on controller.
  5. Remove 7.5A fuse from control panel.
  6. Remove front panel and intake side panel.

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →