Generac G-Force 1000 Series — Automatic Transfer Operation Setup
Operation · Transfer switch and control panel
For the Generac G-Force 1000 Series, from the Generac owner's manual.
Applies to: Generac G-Force 400 Series engine, Generac G-Force 800 Series engine, Generac G-Force 1000 Series engine
Procedure
- Verify transfer switch main contacts are set to UTILITY.
- Verify normal utility power source voltage is available to loads connected to transfer switch.
- Press AUTO button on control panel.
- Set MLCB (generator disconnect) to ON (CLOSED).
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.