Generac — Enclosure/Panel Removal

Repair & overhaul

From a Generac service manual covering: QUIETPACT 55, QuietPact 65, QuietPact 75. Check it applies to your exact model before use.

Applies to: Generac QUIETPACT 55, Generac QuietPact 65, Generac QuietPact 75, Generac GTV-760 engine

Procedure

1. Remove enclosure door.
2. Remove nine enclosure roof bolts from perimeter of roof.
3. Remove enclosure side panel bolts and nuts and remove side panel.
4. Remove front and side enclosure panel nut and remove panel.
5. Remove four muffler bolts, loosen clamp and remove muffler.
6. Remove muffler shield bolts and nuts and remove shield.
7. Remove side and back enclosure panel bolts and upper control panel hardware; move control panel down.
8. Remove red and black wires from circuit breaker and ground wires from ground lug.
9. Remove customer-wiring conduit and remaining panel nuts.
10. Remove six air in duct base bolts from top of stator and remove air in duct base.

Full service-parts list: Generac QUIETPACT 55 →, Generac QuietPact 65 →, Generac QuietPact 75 →

Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →