Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Changing the Engine Air Cleaner

Generac 8.1 GN — Changing the Engine Air Cleaner

Maintenance

For the Generac 8.1 GN, from the Generac owner's manual.

Applies to: Generac 8.1 GN, Generac GH-410 engine, Generac GT-530 engine, Generac GT-990 engine, Generac GT-999 engine

Parts for this job

Part numbers from the service-parts list for Generac 8.1 GN. Verify against your serial number before ordering; some links are affiliate links.

Procedure

  1. With the generator shut down, lift the lid and remove the front panel.
  2. Remove cover clips and air cleaner cover (11-22 kW), or disengage wire clip and open access door (8 kW).
  3. Pull out the old air filter and discard.
  4. Thoroughly clean the air cleaner enclosure of dust or debris.
  5. Install a new air cleaner.
  6. Install cover and clips (11-22 kW) or close door and engage wire clip (8 kW).

Full service-parts list: Generac 8.1 GN →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →