Fischer Panda Panda 4K PMS / Panda 5K PMS — Replacement of engine oil and engine oil filter
Maintenance · engine oil and oil filter
For the Fischer Panda Panda 4K PMS / Panda 5K PMS, from the Fischer Panda owner's manual.
Applies to: Fischer Panda Panda 4K PMS, Fischer Panda Panda 5K PMS, Kubota Z482 engine, Kubota EA300 engine
Before you start
- Burn hazard
- Dispose used oil and filter properly
Procedure
- Warm engine about 10 minutes, then wait 3 minutes.
- Prepare oil-resistant mat and collection container.
- Loosen oil filling cap.
- Open oil drain screw with 17 mm wrench and drain oil.
- Remove used oil filter with filter wrench.
- Clean filter holder and oil new filter seal.
- Install new filter by hand.
- Refill engine oil and check level.
- Run engine 10 minutes, stop and check oil-level.
- Clean up oil splashes and check drain screw for leaks.
Tools required
- open-ended wrench 17 mm Amazon
- oil filter wrench Amazon
- container Amazon
- paper towels and cloth Amazon
- oil-resistant mat Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- use new sealing for oil drain screw
Full service-parts list: Fischer Panda Panda 4K PMS →, Fischer Panda Panda 5K PMS →, Kubota Z482 engine →
Source: Fischer Panda owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.