Fischer Panda Panda 15000 — Replacement of the impeller
Maintenance · Raw water pump
For the Fischer Panda Panda 15000, from the Fischer Panda owner's manual.
Applies to: Fischer Panda Panda 15000, Fischer Panda Panda 15000i PMS generator, Kubota D902 engine
Before you start
- Impeller is a wearing part.
Procedure
- Close raw water stop cock.
- Remove raw water pump cover screws.
- Pull impeller from shaft with multigrip pliers; mark position.
- Check impeller for damage and replace if necessary.
- Lubricate impeller with glycerin or silicone spray.
- Fit impeller on shaft in marked position.
- Fasten cover with new seal.
Tools required
- multigrip pliers Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Lubricate impeller with glycerin or non-mineral oil based lubricant
Full service-parts list: Fischer Panda Panda 15000 →, Fischer Panda Panda 15000i PMS generator →, Kubota D902 engine →
Source: Fischer Panda owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.