Fischer Panda Panda 15000 — Replacement of engine oil and engine oil filter
Maintenance · Engine lubrication system
For the Fischer Panda Panda 15000, from the Fischer Panda owner's manual.
Applies to: Fischer Panda Panda 15000, Fischer Panda Panda 15000i PMS generator, Kubota D902 engine
Before you start
- Used oil is toxic and must be disposed properly.
Procedure
- Prepare level generator, run warm, wait 3 minutes.
- Secure against start, open casing, place mat and container.
- Loosen oil filler cap.
- Open oil drain screw with 17 mm wrench and drain oil.
- Remove oil filter with filter wrench counterclockwise.
- Clean filter holder and oil new filter seal.
- Screw in new filter by hand; refit drain screw with new sealing.
- Fill engine oil, checking level every 2 litres.
- Run engine 10 minutes, stop, recheck oil level; clean up.
Tools required
- open-ended wrench 17 mm Amazon
- oil filter wrench Amazon
- container Amazon
- oil resistant mat Amazon
- paper towels Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Oil capacity 3.7 l
- API CF
Full service-parts list: Fischer Panda Panda 15000 →, Fischer Panda Panda 15000i PMS generator →, Kubota D902 engine →
Source: Fischer Panda owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.