Cummins/Onan — Stopping
Operation · Control panel
From a Cummins/Onan operator's manual — check it applies to your exact model before use.
Applies to: Cummins/Onan GGHE, Cummins/Onan GGHF, Cummins/Onan Modified Ford V-10 WSG-1068 engine
Procedure
- Run the generator set at no load for three to five minutes before stopping.
- Move the Run/Stop/Remote switch or remote starting switch to the STOP position.
- If started by an automatic transfer switch, the transfer switch will send a remote (timed delay) stop signal after normal power returns.
- For emergency stop, push in the optional emergency stop button; to reset, pull switch out and move Run/Stop/Remote switch to Stop position, then push test switch to Reset/Lamp Test position.
Full service-parts list: Cummins/Onan GGHE →, Cummins/Onan GGHF →
Source: Cummins/Onan operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.