HomeGeneracGenerac MMG45FHK

Generac MMG45FHK Generator Set

The Generac MMG45FHK is a 35 kW (44 kVA) diesel standby generator set powered by a Kubota V3600-T-E3BG engine. It is available at 120/240 V, 120/208 V and 277/480 V, 3-phase, 60 Hz and rated 95.6 A. It holds about 13.9 L (3.7 gal) of oil and 17.5 L (4.6 gal) of coolant, with a maximum ambient rating of 48.89 °C. Starting uses battery rated 720 CCA. The set measures 2410×890×1320 mm (94.9×35.0×52.0 in), weighs about 1056 kg (2328 lb) and produces 68 dBA at 7.01 m. An integrated tank holds 401.2 L (106.0 gal), roughly 31 hours of runtime. The same V3600-T-E3BG engine also powers generator sets from Magnum.

35 kW
Standby
3.6 L
Displacement
13.9 L
Oil capacity
3
Document types

How to read your Generac serial & model number →

Specifications

Fueldiesel
Frequency60.0 Hz
Standby power35 kW
Standby kVA44
Prime power33 kW
EmissionsInterim Tier IV
ControllerMobile Digital
Oil capacity13.9 L
AlternatorGenerac G350 (6-pole, Class H insulation)
Voltage options120/240 V, 120/208 V, 277/480 V
Phase3-phase
Rated current95.6 A
Power factor0.8
Circuit breaker200 A
Battery cranking720 CCA
Max ambient48.89 °C
Dimensions (L×W×H)2410×890×1320 mm
Dry weight1056 kg
Sound level68.0 dBA @ 7.01 m
Fuel tank401.2 L
Tank runtime31 hr

Engine

Kubota V3600-T-E3BG
Oil capacity13.9 L
Coolant capacity17.5 L
Displacement3.6 L
Aspirationturbocharged
Rated speed1800 rpm

Maintenance & consumables

for the Kubota V3600-T-E3BG
ItemSpecCapacityPart #Interval
Air filter250 hr find
Fuel filter250 hr find
Oil filter500 hr find
Belt500 hr find
Coolant4.7 L2000 hr
Oil4.7 L50 hr

Common questions

What is the power rating of the Generac MMG45FHK?

The Generac MMG45FHK is rated 35 kW standby (44.0 kVA).

What engine does the Generac MMG45FHK use?

The Generac MMG45FHK is powered by the Kubota V3600-T-E3BG engine.

What fuel does the Generac MMG45FHK use?

The Generac MMG45FHK runs on diesel.

What is the oil capacity of the Generac MMG45FHK?

The Kubota V3600-T-E3BG engine in the Generac MMG45FHK has an oil capacity of 13.9 liters.

What alternator does the Generac MMG45FHK use?

The Generac MMG45FHK uses a Generac G350 alternator. It has 6 poles. Insulation class H.

Troubleshooting

6

Symptoms & remedies

SymptomCauseRemedy
Low Fuel Level Shut DownCheck fuel level on LCD display. Check for fuel tank leaks. The engine controller will shut the engine down when there is five percent of fuel remaining in the tank.Check the fuel level sender and connecting wiring for damage. To check for continuity between sender and engine controller, remove the appropriate bolts from control panel to access the inside of the control box. Consult the appropriate DC wiring diagram for the proper path between the engine controller and the fuel level sender.
Low Oil Pressure Shut DownCheck the engine oil level with the dipstick. Add oil if required. Inspect engine for oil leaks.If oil level is good, restart the unit and verify loss of oil pressure. Shut the engine down immediately if the oil pressure value does not read 5 psi (34 kPa) within five seconds. Check oil pressure sender. To identify corrective action, refer to the troubleshooting section of the engine operator’s manual provided with the unit.
Low Coolant Level Shut DownAllow engine to cool. Confirm unit is level to ensure an accurate reading.Check coolant level in radiator. Open the front hood to access the radiator cap. Add coolant until it is 3/4 in. (1.9 cm) below filler neck. Secure the radiator cap back into its original position. Inspect coolant hoses, engine block and water pump for visible leaks. Check engine oil to verify no coolant has mixed with it. Oil will appear milky if coolant is present.
High Coolant Temperature Shut DownCheck coolant level in overflow jug.Restart engine and read coolant temperature to verify high coolant temperature shutdown. Stop engine immediately if coolant temperature is 230°F (110°C) or more. Allow engine to cool. Add coolant to overflow jug if it is low and then check coolant level in radiator. Open front hood to access the radiator cap. Add coolant until it is 3/4 in. (1.9 cm) below filler neck. Secure radiator cap back into its original position. Check radiator shroud and ducting for blockage and remove any foreign matter. Inspect coolant hoses, engine block and water pump for visible leaks. Check the tension of the water pump belt. If no other problems are found, remove the load on the generator and restart the engine. Check the coolant temperature and shut the engine down immediately if it starts to overheat.
Overcrank Shut DownCheck fuel level in tank. Check for proper operation of the fuel pump. Check air filter for blockage.If engine will not start, consult the engine operation and maintenance manual.
Overspeed or Underspeed Shut DownDisconnect all loads and restart generator. Read the frequency (Hz) on the display. With no loads on the generator, the frequency should read 60.0 Hz.If frequency is above or below 60.0 Hz, the engine speed needs to be adjusted. See the engine manual for throttle adjustments on mechanical governed units and see the electronic governor manual for electronically controlled units.

Fault codes and symptom→remedy steps extracted from this model’s service/owner documentation; verify against the official manual before servicing.

Parts

30
Part #DescriptionQtySystem
002823aGrease1Grease PartsGeek
002824aOil1Oil PartsGeek
002825aOil1Oil PartsGeek
18556Regulator, voltage - SE3501Sensor PartsGeek FridayParts $158.99
20450Hose, air intake1Hose PartsGeek
21259Decal, Battery Charger (Optional)1Battery charger decal PartsGeek
22874Element, air filter1Air filter PartsGeek
22967Filter, air1Oil filter PartsGeek
27408Belt, fan1Belt PartsGeek
27470Alternator, engine1Alternator PartsGeek
27471Starter, engine1Starter PartsGeek
34550Decal, 600V Circuit Breakers (MMG45FHKCAN6 only)1Circuit breakers 600v decal PartsGeek
50018Hose, fuel - .312 ID, 50 psi, SAE 30R73Hose PartsGeek
50201Hose, coolant - .625 I.D.2.3Hose PartsGeek
65592Sensor, low coolant1Sensor PartsGeek
000300WARNING: Crushing Hazard. Stay clear of hood and lift structure when opening and closing generator hoods. Failure to do so could result in death or serious injury.Service part / kit PartsGeek
002787WARNING: Crushing Hazard. Stay clear of hood and lift structure when opening and closing generator hoods. Failure to do so could result in death or serious injury.Service part / kit PartsGeek
002788WARNING: Crushing Hazard. Stay clear of hood and lift structure when opening and closing generator hoods. Failure to do so could result in death or serious injury.Service part / kit PartsGeek
19219Cap, radiator - 14.7 psi1Service part / kit PartsGeek
21489Battery disconnect switch - 500A cont.1Service part / kit PartsGeek
24777Cable, red battery 54"1Service part / kit PartsGeek
24778Cable, black battery 15"1Service part / kit PartsGeek
26387Decal Set, Rear Hood Latch1Service part / kit PartsGeek
27187Radiator1Service part / kit PartsGeek FridayParts $59.99
27243Engine, Kubota V36001Service part / kit PartsGeek
27719BTank, fuel - 110 gal1Service part / kit PartsGeek
28964Decal, Engine Block Heater (Optional for MMG45FHK, Standard for MMG45FHKCAN and MMG45FHKCAN6)1Service part / kit PartsGeek
31024Decal, Fan Clutch (Optional for MMG45FHK, Standard for MMG45FHKCAN and MMG45FHKCAN6)1Service part / kit PartsGeek
34424Decal Set, Voltage Selector Switch (x2)1Service part / kit PartsGeek
MMG45KGenerator Make: _______________________________________ Generator Model Number:________________________________ Generator Serial Number: ________________________________Service part / kit PartsGeek

Service, wear & replacement parts referenced for this model and its engine — confirm the exact part for your serial number. See the full parts catalog to search and cross-reference.

Fuel consumption

RatingLoadL/hgal/h
Prime
Prime50%5.71.5
Prime75%8.72.3
Prime100%11.43.0
Standby

Available documents

Spec sheet — MMG45FHK Mobile (Generac)Owner's manual — 24594 (Generac)Owner's manual — 29663 (Generac)Parts manual — 20935 (Generac)

Other sets with this engine