HomeEnginesDetroit Diesel S60

Detroit Diesel S60 Engine

The Detroit Diesel S60 is a 14 L 6-cylinder turbocharged, intercooled engine rated at 1800 rpm, producing up to 474 kW. It powers generator sets from Kohler, including the 350REOZDD, 400REOZD and 450REOZD. It holds 36 L (9.5 gal) of oil and 45.4 L (12.0 gal) of coolant.

Also known as: Detroit Diesel S60

14.0 L
Displacement
6
Cylinders
1800 rpm
Rated speed
474 kW
Gross power

Engine specifications

Oil capacity36.0 L
Coolant capacity45.4 L
Displacement14.0 L
Cylinders6
Aspirationturbocharged, intercooled
Rated speed1800 rpm
Gross power474 kW

Common problems

10
  • Unstable voltage
    Cause: Speed variation in engine. Regulator out of setting.
    Fix: Check regularity of rotation. Regulate stability of regulator by acting on “STABILITY” potentiometer.
  • Rotating bridge failure
    Fix: Check diodes, disconnect cables.
  • Lower than rated voltage at load
    Cause: Voltage potentiometer out of setting. Intervention by protection.
    Fix: Reset voltage potentiometer. Check rpm.
  • Low voltage at no load
    Cause: Voltage potentiometer out of setting. Intervention of protection. Check rpm. Winding failure.
    Fix: Reset voltage. Check rpm. Check windings.
  • Higher than rated voltage at load
    Cause: Voltage potentiometer out of setting. Loose sensing wires on AVR.
    Fix: Reset voltage potentiometer. Check sensing wires on AVR.
  • High voltage at no load
    Cause: Voltage potentiometer out of setting. Failed regulator.
    Fix: Reset voltage potentiometer. Substitute regulator.
  • Engine runs in idle speed
    Cause: No SAPE connected.
    Fix: Put single/parallel switch in single position.
  • Current too high, power factor lower than 0.8; speed lower than 10 % of rated speed
    Cause: Failed regulator.
    Fix: Substitute regulator.
  • Alternator does not excite Blown fuse.
    Cause: Insufficient residual voltage. Increase the speed by 15 %. No residual voltage.
    Fix: For an instant apply on the + and – terminals of the electronic regulator a 12 V battery voltage with a 30 Ω resistor in series respecting the polarities.
  • After being excited alternator does not excite
    Cause: Connections are interrupted.
    Fix: Check connection cables as per attached drawings.

Compiled from service & troubleshooting documentation across every generator set that uses the Detroit Diesel S60.

Maintenance schedule

ItemSpecCapacityPart #Interval
Air filterClean/Replace500 hr
Fuel filterReplace250 hr
Oil filterReplace250 hr
BatteryReplace250 hr
BeltReplace250 hr
CoolantCheck/Clean250 hr
Coolant filter50 hr
OilS436.0 L50 hr
Spark plugCheck/Replace250 hr

Pooled from every document that names this exact engine — confirm the interval and part number against your unit's serial number.

Service specifications

30
TypeItemValueUnitCondition
Other10 in. weld flange bolt circle diameter B361.95mm (14.25 in.)
Other10 in. weld flange outside diameter C406.4mm (16.0 in.)
Other10 in. weld flange quantity of bolts / bolt hole diameter D12, 25.40mm (1.00 in.)
Other12 in. weld flange bolt circle diameter B431.80mm (17.00 in.)
Other12 in. weld flange outside diameter C482.6mm (19.0 in.)
Other12 in. weld flange quantity of bolts / bolt hole diameter D12, 25.40mm (1.00 in.)
Other14 in. weld flange bolt circle diameter B476.25mm (18.75 in.)
Other14 in. weld flange outside diameter C533.4mm (21.0 in.)
Other14 in. weld flange quantity of bolts / bolt hole diameter D12, 28.58mm (1.13 in.)
Other16 in. weld flange bolt circle diameter B539.75mm (21.25 in.)
Other16 in. weld flange outside diameter C596.9mm (23.5 in.)
Other16 in. weld flange quantity of bolts / bolt hole diameter D16, 28.58mm (1.13 in.)
Other18 in. weld flange bolt circle diameter B577.85mm (22.75 in.)
Other18 in. weld flange outside diameter C635.0mm (25.0 in.)
Other18 in. weld flange quantity of bolts / bolt hole diameter D16, 31.75mm (1.25 in.)
Other20 in. weld flange bolt circle diameter B635.00mm (25.00 in.)
Other20 in. weld flange outside diameter C698.5mm (27.5 in.)
Other20 in. weld flange quantity of bolts / bolt hole diameter D20, 31.75mm (1.25 in.)
Other5 in. weld flange bolt circle diameter B215.90mm (8.50 in.)
Other5 in. weld flange outside diameter C241.30mm (9.50 in.)
Other5 in. weld flange quantity of bolts / bolt hole diameter D8, 22.23mm (0.88 in.)
Other6 in. weld flange bolt circle diameter B254.0mm (10.0 in.)
Other6 in. weld flange outside diameter C279.4mm (11.0 in.)
Other6 in. weld flange quantity of bolts / bolt hole diameter D8, 22.23mm (0.88 in.)
Other8 in. weld flange bolt circle diameter B298.45mm (11.75 in.)
Other8 in. weld flange outside diameter C342.9mm (13.5 in.)
Other8 in. weld flange quantity of bolts / bolt hole diameter D8, 22.23mm (0.88 in.)
OtherWeld flange angle A (10, 12, 14 in. nominal pipe size)30deg.
OtherWeld flange angle A (16, 18, 20 in. nominal pipe size)22.5deg.
OtherWeld flange angle A (5, 6, 8 in. nominal pipe size)45deg.

Extracted from the manufacturer documentation linked to this model. Values are copied as printed; confirm against your unit's manual and serial number.

Common questions

What is the oil capacity of the Detroit Diesel S60?

The Detroit Diesel S60 engine has an oil capacity of 36.0 liters.

What is the displacement of the Detroit Diesel S60?

The Detroit Diesel S60 has a displacement of 14.0 liters with 6 cylinders.

Which generators use the Detroit Diesel S60 engine?

The Detroit Diesel S60 powers 3 generator set(s), including Kohler 350REOZDD, Kohler 400REOZD, Kohler 450REOZD.

How often should you change the oil in the Detroit Diesel S60?

The Detroit Diesel S60 oil change interval is every 50 hours.

What is a common problem with the Detroit Diesel S60 engine?

A commonly reported issue on generators using the Detroit Diesel S60 is: Unstable voltage. Cause: Speed variation in engine. Regulator out of setting.. Fix: Check regularity of rotation. Regulate stability of regulator by acting on “STABILITY” potentiometer..