Yanmar — Lube oil and filter replacement
Maintenance · Lubrication system
From a Yanmar service manual covering: 2TNV70, 3TNV70, 3TNV76. Check it applies to your exact model before use.
Applies to: Yanmar 2TNV70, Yanmar 2TNV70 engine, Yanmar 3TNV76 engine
Before you start
- Hot oil can cause burns.
Parts for this job
- 119305-35150 Oil filter — Yanmar 2TNV70 Amazon eBay $13.14 KuduParts $11.00 FridayParts $19.80
- 12445035110 Oil filter — Yanmar 3TNV76 engine Amazon eBay $7.50 PartsGeek $8.97 KuduParts $11.00
Part numbers from the service-parts lists for Yanmar 2TNV70, Yanmar 3TNV76 engine. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Run engine until lube oil is warm, then stop.
- Remove oil filler cap and drain lube oil through drain plug.
- Turn lube oil filter counter-clockwise with filter wrench to remove.
- Clean oil filter mounting face.
- Moisten new oil filter gasket with lube oil.
- Install filter until contact, then tighten 3/4 turn (20-24 N·m).
- Fill with specified lube oil to dipstick range.
- Run five minutes, check leaks, and recheck level after ten minutes.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Oil filter 119305-35150 Amazon eBay $13.14 KuduParts $11.00 FridayParts $19.80
- Tightening torque 20-24 KuduParts $85.00 FridayParts $110.92 N·m
Full service-parts list: Yanmar 2TNV70 →, Yanmar 3TNV76 engine →
Source: Yanmar service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.