Magnum — Light Tower Set Up
Installation
From a Magnum operator's manual covering: MLT5150M, MLT5200IV, MLT5200IVCAN. Check it applies to your exact model before use.
Applies to: Magnum MLT5200IVCAN, Mitsubishi S4L2-W461ML engine, Isuzu 4LE1NYGV-03 or 4LE1NYGV-03E engine, Isuzu 4LE1NYGV-03G engine
Before you start
- The mast extends up to 25 ft (7.6 m). Make sure area above the unit is open and clear of overhead wires and obstructions.
- Consult local codes for proper grounding requirements.
Procedure
- Locate unit at ground level or in a spot higher than the area being illuminated.
- Place unit on firm, relatively flat ground. Block wheels to keep trailer from moving.
- Pull locking pin on tongue jack, rotate 90°, replace pin. Turn jack handle clockwise to raise trailer tongue off towing vehicle.
- Connect earthen ground to grounding stud on trailer frame near trailer tongue.
- Pull locking pin on each outrigger and pull out until spring-loaded pin snaps back. Pull pin on outrigger jack and rotate 90° so jack pad faces down.
- Pull locking pin on rear jack and rotate 90° until spring-loaded pin snaps. Turn jack handle clockwise to level trailer. Adjust all four jacks until firmly in contact with ground and trailer is level.
- Adjust lamps by loosening wing nuts on trunnion, aim as desired, tighten hardware. Ensure lamps connected to junction box.
Specs & values
- Mast extends up to 25 ft (7.6 m)
Full service-parts list: Magnum MLT5200IVCAN →, Mitsubishi S4L2-W461ML engine →
Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.