Magnum — Light Operation
Operation · Lights
From a Magnum operator's manual covering: MLT5150M, MLT5200IV, MLT5200IVCAN. Check it applies to your exact model before use.
Applies to: Magnum MLT5200IVCAN, Mitsubishi S4L2-W461ML engine, Isuzu 4LE1NYGV-03 or 4LE1NYGV-03E engine, Isuzu 4LE1NYGV-03G engine
Before you start
- NEVER OPERATE THE LIGHTS WITHOUT THE PROTECTIVE LENS COVER, OR WITH A LENS COVER THAT IS CRACKED OR DAMAGED.
- Bulbs become extremely hot when in use. Allow bulb fixture to cool 10-15 minutes before handling or lowering the mast.
Procedure
- Once engine up to temperature and running smoothly, switch main circuit breaker to ON/I.
- Switch each individual light circuit breaker to ON/I, one at a time.
- Ballast indicator lights will come on and brighten as lights warm up, then remain on.
- If an indicator light does not come on, ballast may need service. If lit but light not illuminated, check bulb or mast wiring.
- Lights require 5-15 minutes warm up. After shutdown, require about 10 minutes cool down before restarting.
- Uses four 1000W bulbs. Wipe bulbs clean when replacing.
Specs & values
- 5-15 minutes warm up
- 10 minutes cool down
- four 1000W Amazon eBay FridayParts $24.50 bulbs
Full service-parts list: Magnum MLT5200IVCAN →, Mitsubishi S4L2-W461ML engine →
Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.