Kohler — Starting the Generator Set (Local and Auto)
Operation · ADC 2100 controller
From a Kohler operator's manual covering: 10/13/15ERG, 10ERG, 13ERG, 15ERG, TP-6334. Check it applies to your exact model before use.
Applies to: Kohler 10ERG, Kohler 13ERG, Kohler 15ERG
Before you start
- A remote start/stop switch or digital gauge connects to the customer interface connection (P21 connector, leads 3 and 4).
Procedure
- Open the manual fuel shut-off valve, if equipped.
- Local Starting: move the generator set master switch to the RUN position.
- The controller attempts to start the generator set three times. If it does not start in three attempts, the system shuts down on an overcrank fault.
- Auto (Automatic) Starting: move the master switch to the AUTO position to allow startup by the ATS, remote start/stop switch, or remote digital gauge.
Full service-parts list: Kohler 10ERG →, Kohler 13ERG →, Kohler 15ERG →
Source: Kohler operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.