Kohler KDI 1903 TCR / KDI 2504 TCR — Engine oil replacement
Maintenance
For the Kohler KDI 1903 TCR / KDI 2504 TCR, from the Kohler owner's manual.
Applies to: Kohler KDI 1903 TCR, Kohler KDI 2504 TCR
Before you start
- Disconnect negative battery wire to avoid accidental engine starting.
- The oil must be drained whilst engine is hot; prevent burns.
Parts for this job
Part numbers from the service-parts lists for Kohler KDI 1903 TCR, Kohler KDI 2504 TCR. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Loosen oil filler cap A.
- Remove oil dipstick B.
- Remove oil drain plug D and gasket E.
- Drain oil into appropriate container.
- Replace gasket E.
- Tighten oil drain plug D to 35 Nm.
- Add recommended type and amount of oil.
- Use oil filler cap C if plug A is not accessible.
- Fit and remove oil dipstick B to check level; pour fluid to MAX.
- Reinstall oil dipstick B completely.
- Tighten cap A or C.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 35 Nm
Full service-parts list: Kohler KDI 1903 TCR →, Kohler KDI 2504 TCR →
Source: Kohler owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.