Kohler — Generator Storage Procedure
Maintenance · Generator set
From a Kohler operator's manual covering: 10/13/15ERG, 10ERG, 13ERG, 15ERG, TP-6334. Check it applies to your exact model before use.
Applies to: Kohler 10ERG, Kohler 13ERG, Kohler 15ERG
Before you start
- Run the generator set once a month whenever possible.
Procedure
- Start and run the generator set until it reaches operating temperature or about 15 minutes.
- Stop the generator set.
- Change the oil and oil filter.
- Drain the fuel completely from the fuel tank.
- Check the engine coolant protection; use antifreeze capable of withstanding the lowest possible temperatures.
- Keep spark plugs in their holes or seal spark plug holes with suitable threaded metal plugs.
- Clean the exterior and spread a light film of oil or silicon spray over exposed surfaces.
- Seal the air inlet, exhaust pipe, and fuel tank cap with tape.
- Disconnect and remove the battery; store in a warm, dry location. Recharge the battery once a month.
- Select a well-ventilated (not humid or dusty) location to store the generator.
- Cover the entire unit with a dust cover.
Full service-parts list: Kohler 10ERG →, Kohler 13ERG →, Kohler 15ERG →
Source: Kohler operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.