Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Kohler›Setting the Exerciser on the RDC2 Controller

Kohler 14RES / 20RES — Setting the Exerciser on the RDC2 Controller

Operation

For the Kohler 14RES / 20RES, from the Kohler operator's manual.

Applies to: Kohler 14RES, Kohler 20RES, Kohler CH 740 engine, Kohler CH1000 engine

Before you start

  • Use caution navigating controller menus

Procedure

  1. Press AUTO on controller.
  2. Press Select to go to main menu.
  3. Step to Genset System menu and press Select.
  4. Step to Next Exercise menu.
  5. Press and hold Select to enable editing.
  6. Press Select so setting flashes; use Up/Down arrows to change.
  7. Press Select to save each setting.
  8. Set exercise mode: Unloaded Cycle, Unloaded Full, or Loaded Full.
  9. Set exercise frequency weekly or every two weeks.
  10. Step to Return and press Select.

Full service-parts list: Kohler 14RES →, Kohler 20RES →

Source: Kohler operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Kohler repair guides →