Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Starting the Generator

Generac PRIMEPACT 70 — Starting the Generator

Operation · Generator control panel

For the Generac PRIMEPACT 70, from the Generac owner's manual.

Applies to: Generac PRIMEPACT 70, Generac GN-480 engine

Before you start

  • If the engine does not start after cranking for 15 seconds, release the Start/Stop switch and wait 1 minute before trying again.
  • Holding the switch longer than 15 seconds can damage the starter motor.

Procedure

  1. Turn OFF electrical loads using the means provided in the vehicle.
  2. If not started in more than two weeks, press the Fuel Pump Primer switch for about 10 seconds.
  3. Hold the Start/Stop switch at START and release when the engine starts.
  4. Let the engine run at no-load for a few minutes to stabilize and warm up.
  5. Turn ON electrical loads using the means provided.

Full service-parts list: Generac PRIMEPACT 70 →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →