Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Change Oil Filter

Generac NP-66G — Change Oil Filter

Maintenance · Engine

For the Generac NP-66G, from the Generac owner's manual.

Applies to: Generac NP-66G, Generac GN-480 engine

Parts for this job

Part numbers from the service-parts list for Generac NP-66G. Verify against your serial number before ordering; some links are affiliate links.

Procedure

  1. Turn oil filter counterclockwise to remove.
  2. Coat gasket of new filter with engine oil.
  3. Turn new filter clockwise until its gasket contacts tightly with the filter adapter.
  4. Tighten with an additional 3/4 to one turn by hand.
  5. Run engine and check for leaks.

Specs & values

  • FRAM PH #3614

Full service-parts list: Generac NP-66G →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →