Generac NP-66G — Change Engine Oil
Maintenance
For the Generac NP-66G, from the Generac owner's manual.
Applies to: Generac NP-66G, Generac GN-480 engine
Before you start
- DO NOT OVERFILL ABOVE "FULL" MARK.
Parts for this job
- 70185 Oil filter Amazon eBay $18.99 NAPA $9.09 KuduParts $11.00
Part numbers from the service-parts list for Generac NP-66G. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Warm up engine for at least five minutes, then shut down.
- With engine still warm, remove oil drain plug and drain oil completely into a suitable container.
- Install and tighten oil drain plug.
- Remove oil dipstick and fill crankcase with recommended oil.
- Install and tighten dipstick cap before operating engine.
Specs & values
- Crankcase capacity about 1.7 liters
- SAE 10W-30 Amazon eBay $54.99 API SF
Full service-parts list: Generac NP-66G →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.