Generac NP-30G — Testing under load
Installation · Generator
For the Generac NP-30G, from the Generac owner's manual.
Applies to: Generac NP-30G, Generac GN-220 engine
Before you start
- Do not allow the unit to overheat during prolonged operation.
Procedure
- Apply electrical loads equal to about 75-100% of the unit's rated wattage/amperage capacity.
- Let the unit run at least 30 minutes with load applied.
- Check that the unit is not running excessively hot and that adequate cooling air flow is available.
Specs & values
- Run at least 30 minutes with load applied.
Full service-parts list: Generac NP-30G →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.