Generac NP-30G — Return Unit to Service After Storage
Operation · Generator storage
For the Generac NP-30G, from the Generac owner's manual.
Applies to: Generac NP-30G, Generac GN-220 engine
Before you start
- DO NOT USE TAP WATER IN THE BATTERY
Procedure
- Check tag on engine for oil viscosity and classification; drain and refill with proper oil if necessary.
- Check battery, fill cells with distilled water and recharge to 100% state of charge or replace.
- Turn OFF all electrical loads, then start the engine.
- Let engine warm up.
- Apply electrical loads to at least 50% of the unit's rated wattage capacity.
- When engine is thoroughly warmed up, shut it down.
Full service-parts list: Generac NP-30G →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.