Generac MLT4150MV — Light Tower Setup
Installation · Trailer / mast
For the Generac MLT4150MV, from the Generac owner's manual.
Applies to: Generac MLT4150MV, Mitsubishi S4L2 engine
Before you start
- Verify area above unit is clear of overhead wires before raising the mast
Procedure
- Position unit at ground level or higher than the area to be illuminated
- Place unit on firm, relatively flat ground (less than 5° slope) and block wheels
- Rotate the tongue jack 90° and raise the trailer tongue off the towing vehicle
- Use the grounding stud on the frame per NEC and local regulations
- Pull outrigger locking pins and extend outriggers until pins snap into place
- Rotate rear jack 90° and lower it, then level the trailer with all four jacks
- Adjust lamp aim by loosening trunnion wing nuts, then tighten hardware
Full service-parts list: Generac MLT4150MV →, Mitsubishi S4L2 engine →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.