Generac MDE330 — Connecting to Lugs
Installation · Connection lugs
For the Generac MDE330, from the Generac owner's manual.
Applies to: Generac MDE330, Perkins 1706J-E93TAG2 engine
Before you start
- Electrical backfeed. Use only approved switchgear to isolate generator.
Procedure
- Verify main circuit breaker and battery disconnect switch are OFF.
- Route power cables through opening in bottom of door.
- Connect cables using a hex-wrench.
- Tighten set screws on connection lug to 30 ft-lb (41 Nm).
Tools required
- Hex-wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 30 ft-lb (41 Nm)
Full service-parts list: Generac MDE330 →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.