Fischer Panda Panda 19i / Panda 19i PMS — Replacing engine oil and engine oil filter
Maintenance
For the Fischer Panda Panda 19i / Panda 19i PMS, from the Fischer Panda owner's manual.
Applies to: Fischer Panda Panda 19i, Kubota D902 engine
Before you start
- Used oil is toxic; dispose properly.
- Burn hazard
Parts for this job
- 7665025430 Oil filter — Kubota D902 engine Amazon eBay $22.12 PartsGeek $7.98 NAPA $13.30
Part numbers from the service-parts lists for Fischer Panda Panda 19i, Kubota D902 engine. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Warm engine about 10 minutes, wait 3 minutes.
- Secure generator, open casing, prepare oil-resistant mat and container.
- Loosen oil filler cap.
- Open oil drain screw with 17 mm wrench and drain used oil.
- Remove used oil filter with filter wrench.
- Clean filter holder and oil new filter seal.
- Screw in new filter by hand; refit oil drain screw with new sealing.
- Fill engine oil; check level every 2 litres.
- Run engine 10 minutes, stop, check level and top up.
- Clean up and dispose of oil and filter properly.
Tools required
- Open-ended wrench 17 mm Amazon
- Oil filter wrench Amazon
- Container Amazon
- Paper towels Amazon
- Oil-resistant mat Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Oil fill capacity: see engine technical data
- API CF
Full service-parts list: Fischer Panda Panda 19i →, Kubota D902 engine →
Source: Fischer Panda owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.