Fischer Panda Panda 19i / Panda 19i PMS — Checking oil level
Maintenance · Engine
For the Fischer Panda Panda 19i / Panda 19i PMS, from the Fischer Panda owner's manual.
Applies to: Fischer Panda Panda 19i, Kubota D902 engine
Before you start
- Burn hazard: generator and coolant can be hot.
Procedure
- Place generator or vehicle level.
- Run generator about 10 minutes to warm engine, then wait 3 minutes.
- Secure against accidental start and open casing.
- Pull out, clean and reinsert oil dipstick; wait 10 seconds.
- Read oil level at lower end of stick.
- Recommended level is 2/3 between MIN and MAX.
- Refill if below 1/3.
Tools required
- Paper towels or cloth Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Ideal oil level: 2/3 MAX
Full service-parts list: Fischer Panda Panda 19i →, Kubota D902 engine →
Source: Fischer Panda owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.