Fischer Panda Panda 15 mini PMS Digital — Replacement of engine oil and engine oil filter
Maintenance · Engine oil system
For the Fischer Panda Panda 15 mini PMS Digital, from the Fischer Panda owner's manual.
Applies to: Fischer Panda Panda 15 mini PMS Digital, Kubota D902 engine
Before you start
- Generator and coolant can be hot during and after operation.
Parts for this job
- 7665025430 Oil filter — Kubota D902 engine Amazon eBay $22.12 PartsGeek $7.98 NAPA $13.30
Part numbers from the service-parts lists for Fischer Panda Panda 15 mini PMS Digital, Kubota D902 engine. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Warm engine 10 minutes; wait 3 minutes.
- Assure no accidental start; open casing.
- Place oil resistant mat and container; release/open oil drain hose.
- Unscrew oil filling cap.
- Open oil drain screw with 17 mm wrench; drain oil.
- Remove oil filter with filter wrench; clean oil screen if EA300.
- Oil new filter seal; screw in by hand.
- Refit drain screw with new sealing.
- Fill engine oil; check level every 2 litres.
- Run engine 10 minutes; check level.
- Clean up oil splashes and check drain screw for leaks.
Tools required
- open-ended wrench 17 mm Amazon
- oil filter wrench Amazon
- container Amazon
- oil resistant mat Amazon
- paper towels Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Use a new sealing for the oil drain screw
Full service-parts list: Fischer Panda Panda 15 mini PMS Digital →, Kubota D902 engine →
Source: Fischer Panda owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.