Doosan — Starting
Operation · Genset
From a Doosan owner's manual covering: G 100, G100-SIIIA, G100SIIIA, G150, G150-SIIIA, G200-SIIIA, G60, G60-SIIIA, G60SIIIA, G80, G80-SIIIA, G80SIIIA. Check it applies to your exact model before use.
Applies to: Doosan G100-SIIIA, Doosan G150-SIIIA, Doosan G200-SIIIA, Doosan G60-SIIIA, Doosan G80-SIIIA, John Deere 4045HFG81 engine, John Deere 4045HFG82 engine, John Deere 6068HFG82 engine
Before you start
- Do NOT use engine starting fluids.
- Allow starter to cool one minute between start attempts.
Procedure
- Verify all external electrical power loads are OFF.
- Verify main breaker is OFF.
- Verify battery disconnect switch is ON.
- Reset (pull to unlatch) Emergency Stop Button.
- Push controller START button.
- Wait for preheating if enabled.
- Allow engine to warm up 3 to 5 minutes.
- Check control panel for proper voltages and no red diagnostic lamps.
Full service-parts list: Doosan G100-SIIIA →, Doosan G150-SIIIA →, Doosan G200-SIIIA →, Doosan G60-SIIIA →, Doosan G80-SIIIA →, John Deere 4045HFG81 engine →, John Deere 6068HFG82 engine →
Source: Doosan owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.