Cummins/Onan — Mounting the Generator Set
Installation · Skid/Base
From a Cummins/Onan service manual — check it applies to your exact model before use.
Applies to: Cummins/Onan GGHE, Cummins/Onan GGHF, Cummins/Onan WSG-1068 engine
Before you start
- Use of unapproved isolators may result in harmful resonances and void warranty
Procedure
- Mount generator set on substantial, level, non-combustible base such as concrete pad.
- Use 5/8 inch or 16 mm anchored mounting bolts to secure skid to floor.
- Secure skid using flat washer and hex nut for each bolt.
- Insert 1-1/2 x 6 inch pipe over mounting bolts to allow adjustment alignment to skid holes.
- Provide at least 1 meter (3 feet) clearance on all sides for maintenance and service access.
Specs & values
- 5/8 inch or 16 mm anchor bolts
- 1 meter (3 ft) minimum clearance
Full service-parts list: Cummins/Onan GGHE →, Cummins/Onan GGHF →
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.