Cummins/Onan — Genset Harness Installation
Installation
From a Cummins/Onan service manual — check it applies to your exact model before use.
Applies to: Cummins/Onan HDKA, Cummins/Onan HDKB, Cummins/Onan HDKC
Before you start
- CAUTION! When DC wires are run with AC wires, electrical induction can occur; route the controller harness separately from AC load wires.
- WARNING! Exhaust gases are hazardous and may cause severe personal injury or death. Seal all holes to prevent entrance of exhaust gases into the vehicle interior.
Procedure
- Route the harness from the genset to the control panel, making sure connectors match at each end.
- Protect wires from all hot, sharp, and abrasive surfaces.
- Seal any holes where the harness passes through bulkheads.
Full service-parts list: Cummins/Onan HDKA →, Cummins/Onan HDKB →, Cummins/Onan HDKC →
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.