Westinghouse — Starting iGen1200
Operation · inverter
From a Westinghouse owner's manual covering: iGen1200, iGen2000, iGen2500, iPro2500. Check it applies to your exact model before use.
Applies to: Westinghouse iGen1200
Procedure
- Make sure nothing is plugged into power outlets.
- Turn the fuel tank vent to the ON position.
- Turn the engine/fuel control switch to the ON position.
- Move the choke lever to the CHOKE position.
- Firmly grasp and pull the recoil handle slowly until you feel increased resistance, then apply a rapid pull while pulling out from the inverter.
- As the engine starts and stabilizes, gradually move the choke lever back to the RUN position.
- Plug in electronic devices.
Full service-parts list: Westinghouse iGen1200 →
Source: Westinghouse owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.