Wacker Neuson G 25 — Preparing for Automatic/Remote Start-Up (Basler)
Operation · Remote start circuit
For the Wacker Neuson G 25, from the Wacker Neuson owner's manual.
Applies to: Wacker Neuson G 25
Before you start
- Be prepared for engine startup in REMOTE START position.
Procedure
- Perform a manual start to verify the LCD panel; check fuel and battery.
- Attach a jumper wire between the two remote run terminals.
- Set engine start switch to REMOTE START.
- Wait for engine to crank, start, and run.
- Move engine start switch to OFF to stop.
- Remove jumper wire.
- Set voltage selector switch to correct position.
- Set engine start switch to REMOTE START.
- Set main line circuit breaker to ON.
- Secure generator by closing and locking all doors.
Tools required
- Jumper wire (minimum 16-gauge insulated) Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Remote distance max 1,219 m (4,000 ft)
- Twisted 22-gauge wire or heavier
Source: Wacker Neuson owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.