Wacker Neuson G 25 — Cleaning the DPF (Manual Regeneration)
Maintenance · Diesel Particulate Filter
For the Wacker Neuson G 25, from the Wacker Neuson owner's manual.
Applies to: Wacker Neuson G 25
Before you start
- Burn hazard. Do not touch engine, DPF, or exhaust pipe while operating.
Procedure
- Start the engine at low idle speed.
- Move the manual regeneration switch to the on position and hold for five seconds.
- Release the switch.
- Regeneration runs; engine speed increases to about 1000 rpm.
- Engine returns to low idle (about 750 rpm) when complete.
Specs & values
- Regeneration may continue up to one hour
- Regeneration speed about 1000 rpm
- Low idle about 750 rpm
Source: Wacker Neuson owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.