Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Volvo Penta›Parameter setting connection

Volvo Penta TAD1240-42GE / TWD1240VE — Parameter setting connection

Adjustments · EDC III

For the Volvo Penta TAD1240-42GE / TWD1240VE, from the Volvo Penta service manual.

Browse Volvo Penta generators & specs →

Procedure

  1. Connect laptop using T-piece 874427 and communication cable 885337.
  2. Install the 'Parameter setting tool' software.
  3. Switch the ignition (do not start the engine).
  4. Start the parameter setting tool and follow instructions in the accompanying manual.
  5. Finish programming by switching off the ignition with the 'AUX STOP' button.

Tools required

Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.

Source: Volvo Penta service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Volvo Penta repair guides →