Volvo Penta — Starting the engine
Operation · Engine / EVC system
From a Volvo Penta service manual — check it applies to your exact model before use.
Browse Volvo Penta generators & specs →
Before you start
- Never use start spray or similar starting aids (explosion risk).
- Never disconnect the current with the main switches when the engine is running.
- Never race the engine when it is cold.
Procedure
- Put the reverse gear/stern drive in neutral at all control positions.
- Turn the starter key to position I to switch the ignition on; check warning lamps and LEDs.
- Activate the control panel by pressing the activation button for at least one second.
- Press the activation button a further second to lock the system if desired.
- Turn the key to position III (or press the starter button); release as soon as the engine starts.
- Stop cranking if the engine does not start within 20 seconds.
- Allow the engine to idle for the first ten seconds and check instruments and alarms.
- Warm the engine up at low speed and low load before using full power.
Specs & values
- Max cranking time: 20 seconds
- Max engine speed with shift disengaged: 1500 rpm
Source: Volvo Penta service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.